An HW-7 that Glows in the Dark

Hi Bill,

You are right, there is a lot of disdain for the HW7 out there.

While looking for a reasonable selection of do-able modifications to the HW7, I observed a sentiment that when all boiled down would sound like this: “Yea, rip out the innards and build a new transceiver in the carcass that is left.”

On the flip side, I have experienced relatively good results from my virgin HW7. Oh yea, I did add dial and meter lighting along with A nice set of Radio Shack Knobs but that is about the extent of the changes.

So Bill, I was wondering if any listeners to Solder Smoke know of a good source of reasonable modifications to the HW7 without inducing an implant? Second, is there a way of adding an S-meter to a direct conversion receiver? Are there any mods that can be lifted from the HW8 or HW9 and applied to the Old Senior HW7?

Thanks & 73’s

Harv WA3EIB Albuquerque, NM

Our book: “SolderSmoke — Global Adventures in Wireless Electronics”http://soldersmoke.com/book.htmOur coffee mugs, T-Shirts, bumper stickers: http://www.cafepress.com/SolderSmokeOur Book Store: http://astore.amazon.com/contracross-20

2 thoughts on “An HW-7 that Glows in the Dark”

Leave a Reply to Anonymous Cancel reply

Your email address will not be published. Required fields are marked *