I’m kind of behind on podcast production, but once again I have a good excuse: I’ve been melting solder. I decided to finally finish the Kick Panel DSB rig that I started building back in London. It is built on a kitchen cutting board purchased in a Dyas store in Windsor. The cabinet is fashioned from an aluminum kick panel for a door (a pub door!).
I originally intended this to be just a transmitter (for use with my trusty Drake 2-B) but it is so easy to add a direct conversion receiver to a DSB rig that I just threw together a version of the NE-602 LM386 Neophyte receiver and hooked it up to the 75 meter VFO. It sounds great. I love DC receivers. They seem to connect you directly to the ether. And now I’ll have a complete 75 meter DSB station in one box.
This morning I tested the balanced modulator (singly balanced with two diodes). DSB is being generated. All I have to do now is put a little 6 db pad between the modulator and the amplifier chain, then work on the antenna a bit and I should be on 75. The amplifier chain dates back to the period when Mike, KL7R, and I were using LTSpice to design amps….
I was very pleased to include in this rig a part that Michael, AA1TJ, sent me: I have a little 10.7 MHz IF can in the front end of the RX. A cap allows it to tune in 75 meters. Thanks Mike!
I hope to get a podcast out this weekend (if the computers cooperate — the Sony Vaios “light bulb-repaired” laptop finally gave up the ghost last weekend.)
Our book: “SolderSmoke — Global Adventures in Wireless Electronics” http://soldersmoke.com/book.htm Our coffee mugs, T-Shirts, bumper stickers: http://www.cafepress.com/SolderSmoke Our Book Store: http://astore.amazon.com/contracross-20